- Conventional milling
- Climb milling
- Face milling
- End milling
Answer: Option 1 Let'
1 Answers 1 viewsAnswer: Option 4 Let'
1 Answers 1 viewsAnswer: Option 2 In Down milling operation, the cutting force is maximum when the tooth begins its cut and reduces it to minimum when the tooth leaves the work.
1 Answers 1 viewsAnswer: Option 3 Let'
1 Answers 1 viewsAnswer: Option 2 The Intel 8080 was a jazzed-up calculator chip. It was included in microcomputer kits which were little more than demonstration tools and did little except blink lights....
1 Answers 2 viewsAnswer: Option 1 The ratio of the thickness of thermal boundary layer to the thickness of hydrodynamic boundary layer is equal to -1/3
1 Answers 1 viewsAnswer: Option 4 For maximum work, the reheating should be done to an intermediate pressure of p₁ p₂ Where, p₁ = Maximum pressure, p₂ = Minimum pressure
1 Answers 1 viewsAnswer: Option 2 Let'
1 Answers 4 viewsAnswer: Option 2 Insurance refers to protection against an event that might happen whereas Assurance refers to protection against an event that will happen.
1 Answers 1 viewsAnswer: Option 3 Let'
1 Answers 1 views