সরাসরি ভিডিও কলে পরামর্শ নিন
Bissoy অ্যাপ এ
পরামর্শ দিয়ে $ টাকা $ উপার্জন করুন

This collar is too limp _এর অর্থ ___

সঠিক উত্তর: এই কলারটি বড্ড নরম
This collar is too limp _এর সঠিক অর্থ হচ্ছে___ এই কলারটি বড্ড নরম

If joint is to fail by crushing of socket collar then estimate the diameter of socket collar. Given Permissible compressive stress= 126.67 N/mm².; Spigot dia=65mm; thickness 0f collar=15mm

A machine vice whose length of the handle is 150mm and the coefficient of friction for thread and collar are 0.15 and 0.17 respectively has a force applied at handle of 125N. Also the outer and inner diameters of collar are 55mm and 45mm respectively. Find the collar torque in terms of clamping force W assuming uniform wear theory if nominal diameter=22mm and pitch=5mm.

There are blank spaces in the following passage which have been numbered . These numbers are printed below the passage and against each some words are suggested . Find out the word that best fit the blank spaces. Global Strategies to control infective disease have historically included the erection of barriers to international travel and ___ (24) _______. Keeping people with such deadly disease outside national borders has ___ (25) _______ as an important public health policy in the human immunodeficiency virus (HIV) epidemic . Betwwn 29 and 50 countries ___ (26) _____ to have introduced border restrictions on HIV _ positive foreigners ,usually those planning an ___ (27) ___ stay in the country , such as students , workers or seamen.

The nut which has a cylindrical grooved collar at its lower end and this collar fits into a corresponding recess in the adjoining piece is named as.

____________________ roof is similar to the collar beam roof accept that two collar beams which are crossing each other to present an appearance of scissors are provided.

In a collar tie roof, a higher collar position gives a stronger roof.

A machine vice whose length of the handle is 150mm and the coefficient of friction for thread and collar are 0.15 and 0.17 respectively has a force applied at handle of 125N. Also the outer and inner diameters of collar are 55mm and 45mm respectively. Find the screw torque in terms of clamping force W if nominal diameter=22mm and pitch=5mm.

A machine vice whose length of the handle is 150mm and the coefficient of friction for thread and collar are 0.15 and 0.17 respectively has a force applied at handle of 125N. Also the outer and inner diameters of collar are 55mm and 45mm respectively. Find the clamping force W if nominal diameter=22mm and pitch=5mm.

A machine vice whose length of the handle is 150mm and the coefficient of friction for thread and collar are 0.15 and 0.17 respectively has a force applied at handle of 125N. Also the outer and inner diameters of collar are 55mm and 45mm respectively. Find the overall efficiency if nominal diameter=22mm and pitch=5mm.

A line from where fold comes over and divides collar into stand and outer collar section