Get Advice on Live Video Call
Earn $ Cash $ with
consultations on Bissoy App

If nominal shear stress $${\tau _{\text{v}}}$$ exceeds the design shear strength of concrete $${\tau _{\text{c}}}$$, the nominal shear reinforcement as per IS : 456-1978 shall be provided for carrying a shear stress equal to

Correct Answer: $${\tau _{\text{v}}} - {\tau _{\text{c}}}$$

Tresca or maximum-shear stress criteria assumes that yielding occurs when the maximum shear stress reaches a value of the shear stress in the uniaxial tension test. Assume the principal stress being σ1, σ2, σ3 where σ1 is largest, and σ3 is the smallest principal stresses. Find the value of minimum shear stress to cause yielding, given that yield stress in tension is equal to σo?

The design stress, which is more than the damaging stress, is the least unit stress that will render a member unfit for service before the end of its normal life. The design stress factor or factor of safety indicates the margin between design stress and the __________ stress.

Calculate ultimate moment and shear of effective span is 30m, live load is 9kn/m, dead load excluding self weight is 2kn/m, load factors for dead load is 1.4 for live load is 1.6 cube strength of concrete fcu is 50n/mm2 cube strength at transfer is fci is 35n/mm2, tensile strength of concrete Ec is 34kn/mm2 loss ratio ɳ is 0.85 and 8mm diameter high tensile strength fpu is 1500n/mm2 are available for use and the modulus of elasticity of high tensile wires is 200kn/mm2?

The input x(t) and output y(t) of a system are related as $$y\left( t \right) = \int\limits_{ - \infty }^t {x\left( \tau \right)} \cos \left( {3\tau } \right)d\tau .$$     The system is

Consider a system whose input r and output y are related by the equation $$y\left( t \right) = \int\limits_{ - \infty }^\infty {x\left( {t - \tau } \right)} h\left( {2\tau } \right)d\tau $$
Signal Processing mcq question image
Where h(t) is shown in the graph
Which of the following four properties are possessed by the system? BIBO: Bounded input gives a bounded output
Causal: The system is causal.
LP : The system is low pass.
LTI: The system is linear and time-invariant.

If the main reinforcement of the slab is parallel to a T-beam, the transverse reinforcement at mid span of the slab is provided at least __________ of main reinforcement.

The ultimate shear force at a section of an RCC beam is 300 kN. The shear resisted by concrete is 77.5 kN. What is the shear for which shear reinforcement is required?

The strain energy stored in a body due to shear stress, is (where $$\tau $$ = Shear stress, C = Shear modulus and V = Volume of the body)

When a body is subjected to biaxial stress i.e. direct stresses ($${\sigma _{\text{x}}}$$) and ($${\sigma _{\text{y}}}$$) in two mutually perpendicular planes accompanied by a simple shear stress ($${\tau _{{\text{xy}}}}$$ ), then maximum shear stress is

When a body is subjected to a direct tensile stress ($${\sigma _{\text{x}}}$$) in one plane accompanied by a simple shear stress ($${\tau _{{\text{xy}}}}$$ ), the maximum shear stress is