Get Advice on Live Video Call
Earn $ Cash $ with
consultations on Bissoy App

For an SCR the total turn-on time consists of i) Delay time ii) Rise time and iii) Spread time During the delay time the

Correct Answer: anode current flows only near the gate
Initially for a fraction of a microsecond (delay time) after the gate signal is applied the anode current only flows near the gate terminal where the gate current density is maximum, as the gate current takes some time to spread all over the cross section of the device.

For an SCR the total turn-on time consists of i) Delay time ii) Rise time and iii) Spread time During the rise time the

For an SCR the total turn-on time consists of i) Delay time ii) Rise time and the iii) Spread time The spread time interval depends upon

Consider the following statements: 1. The delay time is the time required to reach 50% of the final value in the first time. 2. The rise time is the time required for the response to rise from 10% to 90% of its final value for underdamped systems. 3. The rise time is the time required for the response to rise from 0 to 100% for the underdamped systems. Which of these statements are correct?

A cam should be designed only using uniform rise and fall within half of the cam, the remaining is dwell period, and without any dwell period in between the rise -fall periods and rise and fall periods should be same. The maximum rise in follower is 30 mm. How much the follower will rise when the follower is 120 degrees from its initial position of a cam?

A cam should be designed only using uniform rise and fall within half of the cam, the remaining is dwell period, and without any dwell period in between the rise-fall periods and rise and fall periods should be same. The maximum rise in follower is 45 mm. How much the follower will rise when the follower is 45 degrees from its initial position of a cam?

A cam should be designed only using uniform rise and fall within the second half of cam profile, the first half is dwell period, without any dwell period in between the rise and fall periods and rise and fall periods should be same. The maximum rise in follower is 45 mm. How much the follower will rise when the follower is 120 degrees from its initial position of a cam?

A cam should be designed only using uniform rise and fall within the second half of cam profile, the first half is dwell period, without any dwell period in between the rise and fall periods and rise and fall periods should be same. The maximum rise in follower is 55 mm. How much the follower will rise when the follower is 240 degrees from its initial position of a cam?

A cam should be designed only using uniform rise and fall within first half of cam profile, the remaining is dwell period, and without any dwell period in between the rise-fall periods and rise and fall periods should be same. The maximum rise in follower is 35 mm. How much the follower will rise when the follower is 240 degrees from its initial position of a cam?

A voltage source Vs = Vm sinωt is connected in series with a resistance R and an SCR. At some firing angle delay of α a positive gate pulse is applied to the SCR which turns on the SCR. Considering ideal conditions, at the instant α the voltage at the resistor terminals Vo

A cam should be designed only using uniform rise and fall throughout the cam without any dwell period and rise and fall periods should be same. The follower is making a rise of 40 mm when the shaft is rotated to an angle of 150 degrees. What is the maximum rise in a follower?