Router শব্দটি কোন শব্দ থেকে এসেছে?

Router শব্দটি কোন শব্দ থেকে এসেছে? Correct Answer Route

তথ্য ও যোগাযোগ প্রযুক্তি ২য় অধ্যায়
শেয়ার করুন বন্ধুর সাথে

বিসিএস, ব্যাংক, প্রাইমারি সহ সরকারি বেসরকারি চাকুরীর পরীক্ষার প্রস্তুতির জন্য ডাউনলোড করুন Bissoy অ্যাপ

Related MCQ's

Network 206.143.5.0 was assigned to the Acme Company to connect to its ISP. The administrator of Acme would like to configure one router with the commands to access the Internet. Which commands could be configured on the Gateway router to allow Internet access to the entire network?
1. Gateway (config) # ip route 0.0.0.0 0.0.0.0 206.143.5.2
2. Gateway (config) # router rip
3. Gateway (config-router) # network 206.143.5.0
4. Gateway (config-router) # network 206.143.5.0 default

A group of 2m - 1 routers are interconnected in a centralized binary tree, with router at each tree node. Router I communicate with router J by sending a message to the root of the tree. The root then sends the message back down to J. Then find the mean router-router path length.

An OSPF router receives an LSA, the router checks its sequence number, and this number matches the sequence number of the LSA that the receiving router already has. What does the receiving router do with the LSA?

You have your laptop directly connected into a router's Ethernet port. Which of the following are among the requirements for the copy flash tftp command to be successful?
1. TFTP server software must be running on the router.
2. TFTP server software must be running on your laptop.
3. The Ethernet cable connecting the laptop directly into the router's Ethernet port must be a straight-through cable.
4. The laptop must be on the same subnet as the router's Ethernet interface.
5. The copy flash tftp command must be supplied the IP address of the laptop.

You get a call from a network administrator who tells you that he typed the following into his router:
Router (config) #router ospf 1Router (config-router) #network 10.0.0.0 255.0.0.0 area 0
He tells you he still can't see any routes in the routing table. What configuration error did the administrator make?

You have an interface on a router with the IP address of 192.168.192.10/29. Including the router interface, how many hosts can have IP addresses on the LAN attached to the router interface?

An OSPF router receives an LSA. The router checks its sequence number and finds that this number is higher than the sequence number it already has. Which two tasks does the router perform with the LSA?

An OSPF router receives an LSA. The router checks its sequence number and finds that this number is lower than the sequence number it already has. What does the router do with the LSA?

Which two commands are required for basic OSPF configuration? area ” and “Router ospf ” b) “ area ” and “ area ” c) Only “Router ospf ” d) “ area ” and “Router ospf ”

The corporate office sends you a new router to connect, but upon connecting the console cable, you see that there is already a configuration on the router. What should be done before a new configuration is entered in the router?

X